territories) who are 18 years of age or older. You further certify that you are not a prohibited party under the laws of any applicable jurisdiction and you will not ‐ directly or indirectly ‐ without obtaining prior authorization from FORD and the competent government authorities as required by those laws and regulations: (1) sell, export, re-export, transfer, divert, or dispose of any product offered on this website to any prohibited person, entity, or destination or (2) use the product for any use prohibited by applicable laws, including the laws or regulations of the United States.Īcceptance of Terms and Conditions of Use You specifically acknowledge and understand that products offered on this website are subject to U.S. Department of Commerce, and trade and economic sanctions maintained by the Treasury Department's Office of Foreign Assets Control, in regard to products purchased on this website. NOTE: Several days of driving are required for the transmission to fully adapt.You agree to comply with all applicable export and re-export control laws and regulations, including the Export Administration Regulations maintained by the U.S. Brake gently to a complete stop and hold your foot on the brake for 10 seconds. Continue to accelerate until you achieve 50 mph or the 5-6 upshift.į. Accelerate from rest with light throttle ensuring that the 1-2, 2-3 and 3-4 shifts occur at engine speeds between 1,700-2,000 rpm.Į. Brake very gently to a complete stop and wait at least six seconds while stopped.ĭ. Accelerate from a stopped position with light throttle to 15 mph and remove your foot from the accelerator pedal.ī. Perform adaptive shift strategy learn on a level road surface.Ī. Transmission fluid temperature must be at 175 degrees F or above before proceeding to Step 5.ĥ.
If is is not at 175 degrees F, drive the vehicle for approximately three miles to reach temperature. Verify that the transmission fluid temperature PID is above 175 degrees Fahrenheit. It is critical that TCM KAM is cleared prior to relearning the adaptive tables for the transmission. Unhooking the battery will not clear the TCM KAM. NOTE: For PDS, reset TCM KAM is not the same as clear transmission adaptive tables, which is under the powertrain-transmission menu tree. Scroll down the menu and choose reset TCM KAM. Using PDS, choose all Tests and Calibrations. Using IDS, Open Toolbox, then choose Powertrain, then choose TCM, then choose Reset KAM.ī. NOTE: It is critical that TCM KAM is cleared for this procedure to be fully effective.Ī. From the IDS tool, select Toolbox, then Powertrain, then OBD Test Modes, then Mode Level 9 Vehicle Info, then TCM Cal Part Number.ģ, Clear TCM keep alive memory (KAM) and adaptive tables. Verify that the TCM calibration is A元P-7J104-AC for all vehicles except the F-150 4x4, which requires A元P-7J104-BC.ī.
Reprogram using the PMI function to ensure that engine and transmission calibrations are updated to the latest level simultaneously.Ī.
Calibration files may also be obtained at NOTE: The TCM cannot be independently reprogrammed. This new calibration is not included in the VCM 2010.5 DVD. Reprogram the powertrain control module (PCM)/transmission control module (TCM) calibration using IDS release 67.03 and higher.
#Broken ford ids install#
Install Integrated Diagnostic System (IDS)/Portable Diagnostic Software (PDS) or equivalent and ID vehicle.Ģ. Some 2009-2010 Ford Expedition and Navigator vehicles built on or before 5-1-20-2010 F-150 vehicles built on or before 2-1-2010 and equipped with the 5.4L 3V engine and 6R80 transmission may exhibit a delayed-then-harsh downshift during a commanded downshift at speeds above 40 mph.ġ.